Tested Material Used To 300-610 Test Engine Exam Questions in here [Dec-2021]
Penetration testers simulate 300-610 exam PDF
Cisco 300-610 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
NEW QUESTION 63
An engineer is designing a Multichassis EtherChannel topology in which two switches must appear as a single device to a third downstream switch? Which two technologies meet this requirement? (Choose two.)
- A. HSRP
- B. vPC
- C. VSS
- D. 802.1q
- E. FEX
Answer: B,C
Explanation:
Section: Compute Design
Explanation/Reference:
Reference: https://www.cisco.com/c/dam/en/us/products/collateral/switches/nexus-7000-series-switches/C07-
572835-00_NX-OS_vPC_DG.pdf
NEW QUESTION 64
An engineer is expanding an existing iSCSI environment and must choose an addressing scheme. When checking one of the devices, the engineer discovers this target device naming used:
{prefix}.2019-01.com.acme123:00.ffd0cb21.bcb392817521
Which addressing scheme was used in the environment?
- A. Network Address Authority
- B. Extended Unique Identifier
- C. Fibre Channel ID
- D. iSCSI Qualified Name
Answer: B
NEW QUESTION 65
An engineer must use OTV for Layer 2 connectivity between data centers to support virtual machine mobility between the customer sites. To support this requirement, the engineer must ensure the existence of the same default gateway on both sites. Additionally, the operations team reports high bandwidth utilization on site A and wants to optimize the outbound traffic flows to use a local DC exit point.
Which feature must be used to meet these requirements?
- A. ARP filter
- B. control group
- C. data group
- D. FHRP filter
Answer: B
NEW QUESTION 66
Refer to the exhibit.
A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?
- A. Cisco UCS Manager creates a single fabric port channel.
- B. Cisco UCS Manager creates two separate fabric port channels.
- C. Each uplink that connects an IOM is configured as a discrete link.
- D. The port channel is disabled until an administrator enables it manually.
Answer: B
Explanation:
Section: Compute Design
NEW QUESTION 67
An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations.
Which two features must be used to prevent these situations from happening in the future? (Choose two.)
- A. peer-gateway
- B. delay restore
- C. system priority
- D. auto-recovery
- E. ip arp synchronize
Answer: B,D
NEW QUESTION 68
An engineer must use OTV for layer 2 connectivity between data centers to support virtual machine between the customer sites. To support this requirement, the engineer must ensure the existence of the same default gateway on both sites. Additionally, the operations team report high bandwidth utilization on site A and wants to optimize the outbound traffic flows to use a DC exit point. Which feature must be used to meet these requirement?
- A. Data group
- B. ARP filter
- C. Control group
- D. FHRP filter
Answer: D
Explanation:
https://www.cisco.com/c/dam/en/us/products/collateral/switches/nexus-7000-series-switches/guide_c07-728315.pdf
NEW QUESTION 69
Refer to the exhibit.
The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?
- A. 2000 bytes
- B. 9000 bytes
- C. 2240 bytes
- D. 2158 bytes
Answer: A
NEW QUESTION 70
An engineer deploys LISP VM mobility. Which feature is configured on the interfaces that have VM mobility enabled?
- A. HSRP
- B. flow control
- C. IP redirects
- D. proxy ARP
Answer: D
Explanation:
Section: Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/lisp/configuration/guide/b_NX- OS_LISP_Configuration_Guide/b_NX-OS_LISP_Configuration_Guide_chapter_010.html
NEW QUESTION 71
An engineer must connect an existing Cisco UCS Fabric Interconnect to an IP-based storage array. The connection must be a port channel made directly between the fabric interconnect expansion module and the storage array. The engineer must also consider that the environment is running FCoE for storage and uses QoS to prioritize traffic.
Which port type should be used to meet these requirements?
- A. appliance
- B. uplink
- C. network
- D. server
Answer: B
NEW QUESTION 72
Which two methods mitigate congestion in a SAN network? (Choose two.)
- A. Configure the port monitor to allow categorization of a specific device as slow.
- B. Use the port-monitor command to detect slow drain devices.
- C. Configure the port channel to enable individual buffer-to-buffer credits.
- D. Configure ER_RDY to allow splitting of each ISL between switches into separate virtual links.
- E. Configure the flow control for the FC to use R_RDY.
Answer: A,B
Explanation:
Section: Storage Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/8_x/config/interfaces/ cisco_mds9000_interfaces_config_guide_8x/congestion_avoidance_isolation.html
NEW QUESTION 73
An engineer is experiencing performance issues on a Cisco UCS blade server. The B-Series blade server contains four CPUs, most of which are idle. The engineer notices that the CPU is suffering from too many requests sent by the NIC. Additionally, the number of queues appears to be insufficient and only a single CPU is processing the network traffic.
Which policy must be used to alleviate these issues?
- A. vNIC placement
- B. dynamic vNIC connection
- C. Ethernet adapter
- D. LAN connectivity
Answer: B
NEW QUESTION 74
An engineer is implementing management access to a Cisco Nexus platform. The customer requires a solution that provides isolation between the data and control planes. In addition to management that uses encryption and authentication. The customer will manage the device using both IPv4 and IPv6. Which two components should be used to meet these requirements (Choose two.)
- A. mgmt0 interface
- B. SSM protocol
- C. SNMP
- D. SVI interface
- E. Telnet protocol
Answer: A,C
Explanation:
We are talking about management only, so SSM is out. Since we need to separate between data and control plane, we should use mgmt0 interface, so SVI interface is out. Since we need to use encryption and authentication, this can be done in SNMPv3, while telnet does not support encryption, so telnet is out.
NEW QUESTION 75
A company has added a new FCoE storage array to increase the performance of datastore access for end users. This storage array is directly connected to the Cisco Nexus 5672UP switches using four 10G port-channel interfaces. After deployment, the end users fail to access the datastore compared to the older solution. A network engineer verified the port-channel interface and finds that the congestion occurs when PFC frames are generated at the FCoE ingress interface. Which action must be taken to resolve the congestion issue?
- A. Reserve bandwidth for FCoE VLAN on the port-channel interface connected with storage.
- B. Add an additional FCoE VLAN to the SAN network.
- C. Enable the FCoE class in QoS on Cisco Nexus 5672UP switches.
- D. Increase the queuing buffer in the port-channel interface connected to the storage array.
Answer: D
NEW QUESTION 76
Which two configurations allow for routing traffic between two VDCs? (Choose two.)
- A. Create interfaces in the VDC that can be accessed by another VDC.
- B. Create VRF-aware software infrastructure interfaces.
- C. Create a policy map in the default VDC that routes traffic between the VDCs.
- D. Cross-connect the ports between the VDCs.
- E. Connect the VDCs to an external Layer 3 device.
Answer: C,E
Explanation:
Section: Network Design
NEW QUESTION 77
An engineer must logically partition two Cisco Nexus 7000 Series Switches into two environments called Test_39919596 and Production_59423879. The environments must use only F2-Series line cards and be limited to a maximum of 265 port-channels. Which Cisco Nexus feature must be used?
- A. VDC
- B. VRF
- C. vPC
- D. vFC
Answer: B
NEW QUESTION 78
Drag and drop the configurations from the left onto the correct policies on the right.
Answer:
Explanation:
NEW QUESTION 79
An engineer is designing a disaster recovery solution. In the event of a node failure, the solution should either direct all of the traffic to another node, or load-balance the traffic across the remaining nodes. Which solution should be implemented in the design?
- A. active/active
- B. warm standby
- C. cold standby
- D. active/passive
Answer: A
NEW QUESTION 80
DRAG DROP
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.
Select and Place:
Answer:
Explanation:
Section: Compute Design
Explanation/Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/unified-computing/ whitepaper_c11-701962.html
NEW QUESTION 81
Which two automation requirements can be met by using Puppet? (Choose two.)
- A. Enable clients to pull changes without installing an agent.
- B. Enable clients to pull changes to configuration files.
- C. Provide support for writing new modules in Python.
- D. Enable one-off infrastructure changes to be performed manually.
- E. Push configuration updates immediately to servers.
Answer: B,E
NEW QUESTION 82
Which element is the main functional component of the architecture that separates the internal fabric and the external network that connects sites when VXLAN EVPN is deployed multisite?
- A. service gateway
- B. border leaf
- C. service leaf
- D. border gateway
Answer: D
NEW QUESTION 83
Drag and drop the SAN components from the left onto the correct design considerations on the right.
Answer:
Explanation:
NEW QUESTION 84
Drag the requirements from the left onto the correct policy types on the right.
Answer:
Explanation:
NEW QUESTION 85
A client in a commercial building Installs a Cisco blade server in the multitenant Cisco UCS blade Infrastructure. To cut operating costs me client's data center is shared with other organizations. The client asks an engineer prevent third parties from accessing their equipment and from accessing BlOS-related information when booting a server. Which Two policies must be used to meet these requirements? (Choose two.)
- A. post error pause
- B. front panel lockout
- C. quiet boot
- D. CDN control
- E. ASPM support
Answer: C,D
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Server-Mgmt/3-2/b_Cisco_UCS_Manager_Server_Mgmt_Guide_3_2/b_Cisco_UCS_Manager_Server_Mgmt_Guide_3_2_chapter_01110.html Quiet boot is what the BIOS displays during booting the server. If enabled, the BIOS displays the logo screen.
I believe that quiet boot and CDN control may have the customer name.
NEW QUESTION 86
A client in a commercial building Installs a Cisco blade server in the multitenant Cisco UCS blade Infrastructure. To cut operating costs me client's data center is shared with other organizations. The client asks an engineer prevent third parties from accessing their equipment and from accessing BlOS-related information when booting a server. Which Two policies must be used to meet these requirements? (Choose two.)
- A. post error pause
- B. front panel lockout
- C. quiet boot
- D. CDN control
- E. ASPM support
Answer: C,D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Server-Mgmt/3-2/b_Cisco_UCS_Manager_Server_Mgmt_Guide_3_2/b_Cisco_UCS_Manager_Server_Mgmt_Guide_3_2_chapter_01110.html Quiet boot is what the BIOS displays during booting the server. If enabled, the BIOS displays the logo screen.
I believe that quiet boot and CDN control may have the customer name.
NEW QUESTION 87
Drag and drop the SAN components from the left onto the correct design considerations on the right.
Answer:
Explanation:
NEW QUESTION 88
......
Authentic Best resources for 300-610 Online Practice Exam: https://www.validvce.com/300-610-exam-collection.html
Get the superior quality 300-610 Dumps with explanations waiting just for you, get it now: https://drive.google.com/open?id=16zqxguUY-ND6OOwCl4TYv4Kgc03K3Eg1
