Free 300-815 Questions for Cisco 300-815 Exam [Feb-2024]
Validate your 300-815 Exam Preparation with 300-815 Practice Test (Online & Offline)
NEW QUESTION # 71
Refer to the exhibit.
An administrator is troubleshooting a situation where a call placed from a phone registered to Cisco Unified Communications Manager does not complete. The administrator wants to use the Dialed Number Analyzer on Cisco Unified CM to check which translation pattern the call is matching. However, when logging in to Cisco Unified Serviceability there is no option for Dialed Number Analyzer under the tool menu. Which two steps must be performed to resolve this issue? (Choose two.)
- A. Activate the Cisco Dialed Number Analyzer Server service.
- B. Activate the Cisco CallManager service.
- C. Activate the Cisco Extended Functions service.
- D. Restart the subscriber
- E. Activate the Cisco Dialed Number Analyzer service.
Answer: A,E
NEW QUESTION # 72
Drag and drop the commands from the bottom to the blanks in the code to implement a translation rule to allow only 11 digits to be received over a SIP trunk to a SIP provider. The Cisco UCM is currently sending calls to the Cisco Unified Border Element in E.
164 format. Not all options are used.
Answer:
Explanation:
NEW QUESTION # 73
A company has users that are logged in to hunt groups. However, there is a requirement for hunt group configurations to provide an option to turn on audible ringtones when calls to a line group arrive at a phone that is logged out and on a break. This ringtone alerts a logged-out user that there is an incoming call to a hunt list to which the line is a member, but the call does not ring at the phone of that line group member because of the logged-out status. Which action meets this requirement?
- A. Configure the HLog softkey on the phone so that while a user is logged off, it plays an audible tone when a call is missed.
- B. Configure the service parameter hunt group logoff notification and specify the name of the ringtone file.
- C. Set the service parameter Enterprise Feature Access number for hunt group logout and set up an access number
- D. Set the service parameter Party Entrance Tone to True."
Answer: B
NEW QUESTION # 74
Which IOS command creates a SIP-enabled dial peer?
- A. dial-peer voice 20 pots
- B. dial-peer voice 20 voip
- C. dial peer voice 20 sip
- D. voice dial-peer 20 sip
Answer: B
Explanation:
Section: Cisco Unified Border Element
Explanation/Reference: https://www.ciscopress.com/articles/article.asp?p=664148&seqNum=6
NEW QUESTION # 75
An administrator is asked to configure egress call routing by applying globalization and localization on Cisco UCM. How should this be accomplished?
- A. Localize the calling and called numbers to E. 164 format and globalize the called number in the gateway.
- B. Globalize the calling and called numbers to E. 164 format and localize the called number in the gateway.
- C. Localize the calling and called numbers to PSTN format and globalize the calling and called numbers in the gateway.
- D. Globalize the calling and called numbers to PSTN format and localize the calling number in the gateway.
Answer: B
NEW QUESTION # 76
Which top-level IOS command is needed to begin the configuration of a Cisco Unified Communications Manager Express gateway to enable phones to be registered via SIP?
- A. voice register global
- B. allow-connections sip to sip
- C. voice register dn
- D. voice service voip
Answer: D
NEW QUESTION # 77
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?
- A. in the queuing configuration
- B. in Cisco Unified CM Enterprise Parameters
- C. in Cisco Unified CM Service Parameters
- D. in the telephony service configuration
Answer: A
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/200453-Configure-CUCM-Native-Call-Queuing-Featu.html
NEW QUESTION # 78
Refer to the exhibit.
An engineer configures Cisco Unified Border Element to connect the enterprise VoIP network with a SIP telephony provider. Calls are not working in either direction. What must be configured in the dial peer 1 to fix the issue?
- A. session-protocol sipv2
- B. answer-address 555 ........
- C. codec g729
- D. incoming called number 555.......
Answer: D
NEW QUESTION # 79
Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?
- A. Configure IP Address Trusted Authentication for Incoming VoIP Calls.
- B. Enable Secondary Dial tone on Analog and Digital FXO Ports.
- C. Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.
- D. Configure the command no ip address trusted authenticate under "voice service voip".
Answer: A
Explanation:
Section: CME/SRST Gateway Technologies
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/ cmeadm/cmetoll.html#concept_ECC4F4E7ED0F45C594B703EEF34762F2
NEW QUESTION # 80
An administrator discovers that employees are making unauthorized long-distance and international calls from logged-off Extension Mobility phones when the authorized users are away from their desks Which two configurations should the administrator configure in the Cisco UCM to avoid this issue? (Choose two.)
- A. Add the long-distance & international pattern's partitions to the calling search space of the physical phone.
- B. Remove the long-distance & international pattern's partitions from the calling search space of the physical phone.
- C. Add the long-distance & international pattern's partitions to the calling search space of the physical phone's directory number.
- D. Remove the long-distance & international pattern's partitions from the calling search space of the device profile.
- E. Add the long-distance & international pattern's partitions to the calling search space of the device profile
Answer: B,E
NEW QUESTION # 81
An engineer is configuring a call park feature in Cisco Unified Communications Manager Express. Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?
- A. R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002
- B. R2(config-ephone-dn)#park reservation-group 1
- C. R2(config-ephone-dn)#park reservation-group 60
- D. R2(config-ephone-dn)#park-slot timeout 30 limit 2 recall alternate 3002
Answer: A
NEW QUESTION # 82
An engineer is configuring a call park feature in Cisco Unified Communications Manager Express. Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?
- A. R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002
- B. R2(config-ephone-dn)#park reservation-group 1
- C. R2(config-ephone-dn)#park reservation-group 60
- D. R2(config-ephone-dn)#park-slot timeout 30 limit 2 recall alternate 3002
Answer: A
Explanation:
Section: Cisco Unified CM Call Control Features
NEW QUESTION # 83
A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide. To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)
- A. three-way conference
- B. SIP trunk
- C. T.38 fax relay
- D. secure SIP lines
- E. transcoding
Answer: A,C
NEW QUESTION # 84
A user reports when they press the services key they do not receive a user ID and password prompt to assign the phone extension. Which action resolves the issue?
- A. Create the default device profiles for all phone models that are used.
- B. Subscribe the phone to the Cisco Extension Mobility service.
- C. Create the end user and associate it to the device profile.
- D. Assign the extension as a mobile extension.
Answer: B
NEW QUESTION # 85
A network engineer designs a new dial plan and wants to block a certain range of numbers (8135100 through
8135105). What is the most specific route pattern that can be configured to block only the numbers in this range?
- A. 813510[12345]
- B. 81XXXXX
- C. 813510[^0-5]
- D. 813510[012345]
Answer: D
Explanation:
Section: Call Control and Dial Planning
NEW QUESTION # 86
A single site reports that when they dial select numbers, the call connects, but they do not get audio. The administrator finds that the calls are not routing out of the normal gateway but out of another site's gateway due to a TEHO configuration. What is the next step to diagnose and solve the issue?
- A. Verify that the dial peer of the gateway has the correct destination pattern configured.
- B. Verify that the route pattern is not blocking calls to the destination number.
- C. Verify that the route pattern has the correct calling-party transformation mask
- D. Verify that IP routing is correct between the gateway and the IP phone.
Answer: A
NEW QUESTION # 87
In Cisco Unified Communications Manager, which tool do you use to check SIP traces?
- A. OS Administration Page
- B. MTP
- C. CCSIP
- D. RTMT
Answer: D
NEW QUESTION # 88
Which configuration element of a hunt group allows for changing Calling Party Transformations settings?
- A. route group
- B. line group
- C. hunt pilot
- D. hunt list
Answer: C
Explanation:
Reference:
https://community.cisco.com/t5/ip-telephony-and-phones/call-alerting-on-hunt-group-as-shared- line/td-p/2658015
NEW QUESTION # 89 
Refer to the exhibit. Users report that outbound PSTN calls from phones registered to Cisco Unified Communications Manager are not completing. The local service provider in North America has a requirement to receive calls in 10-digit format. The Cisco Unified CM sends the calls to the Cisco Unified Border Element router in a globalized E.164 format. There is an outbound dial peer on Cisco Unified Border Element configured to send the calls to the provider. The dial peer has a voice translation profile applied in the correct direction but an incorrect voice translation rule applied, which is shown in the exhibit. Which rule modified DNIS in the format that the provider is expecting?
- A. rule 1/^\+1\([2-9]..[2-9]......$\)/ /\1/
- B. rule 1 /^\+1\([2-9]..[2-9]......$\)/ /\0/
- C. rule 1 /^/+\([^1].*\)/ /011\1/
- D. rule 1 /^\([2-9]..[2-9]......$\)/ /\1/
Answer: A
Explanation:
Section: Cisco Unified Border Element
Explanation/Reference:
NEW QUESTION # 90
An administrator is configuring a cluster for ILS and wants to limit the amount of entities that Cisco Unified Communications Manager can write to the database for data that is learned through ILS. Which service parameter is used to adjust this limit?
- A. Imported Dial Plan Replication Database Object Lower Limit
- B. ILS Active Learned Object Upper Limit
- C. ILS Max Number of Learned Objects in Database
- D. Global Data Service Parameter Limit
Answer: C
NEW QUESTION # 91
Which services are needed to successfully implement Cisco Extension Mobility in a standalone Cisco Unified Communications Manager server?
- A. Cisco CallManager, Cisco TFTP, and Cisco Extension Mobility
- B. Cisco CallManager, Cisco TFTP, and Cisco CallManager SNMP Service
- C. Cisco Extended Functions, Cisco Extension Mobility, and Cisco AXL Web Service
- D. Cisco TAPS Service, Cisco TFTP, and Cisco Extension Mobility
Answer: A
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_5_2/ccmfeat/ CUCM_BK_C3A84B33_00_cucm-feature-configuration-guide_1052/CUCM_BK_C3A84B33_00_cucm-feature- configuration-guide_chapter_011101.html#CUCM_TK_A337E035_00
NEW QUESTION # 92
Refer to the exhibit.
An engineer configures Cisco Unified Border Element to connect the enterprise VoIP network with a SIP telephony provider. Calls are not working in either direction. What must be configured in the dial peer 1 to fix the issue?
- A. incoming called number 555.......
- B. answer-address 555 ........
- C. codec g729
- D. session-protocol sipv2
Answer: D
NEW QUESTION # 93
An administrator is configuring a cluster for ILS and wants to limit the amount of entities that Cisco Unified Communications Manager can write to the database for data that is learned through ILS. Which service parameter is used to adjust this limit?
- A. Imported Dial Plan Replication Database Object Lower Limit
- B. ILS Active Learned Object Upper Limit
- C. ILS Max Number of Learned Objects in Database
- D. Global Data Service Parameter Limit
Answer: C
Explanation:
Section: Cisco Unified CM Call Control Features
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_5_1SU1/systemConfig/ cucm_b_system-configuration-guide-1251su1/cucm_b_system-configuration-guide-
1251su1_restructured_chapter_0100011.html#CUCM_TK_I7C708C2_00
NEW QUESTION # 94
Which call pickup feature allows users to pick up incoming calls in a group that is associated with their own group?
- A. Directed Call Pickup
- B. Group Call Pickup
- C. BLF Call Pickup
- D. Other Group Pickup
Answer: D
NEW QUESTION # 95
The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses
H.323protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real- Time Transport Protocol traffic that had the one-way audio call.
You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).
- A. H.245 Open Logical Channel Ack
- B. H.245 Open Logical Channel
- C. H.245 Terminal Capability Set
- D. H.225 Connect
Answer: B
NEW QUESTION # 96
......
Check Real Cisco 300-815 Exam Question for Free (2024): https://www.validvce.com/300-815-exam-collection.html
Get all the Information About Cisco 300-815 Exam 2024 Practice Test Questions: https://drive.google.com/open?id=1dsJqdxCXk6MTriWa4VZ35PxceQN5A_2Z
